Total of 26 Steel Bones, 2 Strong Steel Busk Bones (1 inch wide each) at the front, 4 Rigid Steel Plates, and 20 Spiral/Flexible Steel Bones around the corset This Is the upper portion before it reaches the widest point. The corset can draw in your waist and flatten your tummy & suitable for Tight-Lacing , Shaping & Waist Training. Total of 16 Steel bones, including 4 rigid... If there is no gap at the back where the lace is, it means the corset is too big for you. Please use our size chart on the LEFT to choose the size. Shop luvsecretlingerie Heavy Duty 26 Double Steel Boned Waist Training COTTON Underbust Tight Shaper Corset #8596-B. Free delivery and returns on eligible orders How to select the Corset Size? Please take your measurements based on the photos below. This has nothing to do with your bra size. This is the slimmest part of your waist (usually 1 inch above your belly button). The size proposed is 4-5 reduction on your waist when wearing the corset. Upper Hip Measure around the top to your hip bone (not the fullest part of your hip). 100% Cotton Twill Lining with waist tapeCorset Dimension 13.2 (33.5 CM) length for the front (measure from centre) The centre of the corset should be pulled in the most. Make sure the tape is parallel and snug but not too tight. Heavy Duty Double Steel Boned Corset for perfect hourglass figure. The corset size selected based on your waist measurements can fit you well as long as your Underbust & Hip measurements are within the range. Note: Never make a knot out of your laces at the center as it will be very difficult to undo the knot when removing your corset. Open the garment as wide as possible with only a pair of small loops at the centre back. 3. Wrap the corset around your body while adjusting the modesty panel so it would be flat under the laces. Make sure there is 1Â2 inches gap between the two sides of the corset. Luvsecretlingerie Heavy Duty 26 Double Steel Boned Waist Training COTTON & SATIN Underbust Tight Shaper Corset #8960 We propose 4-5 inches reduction on your waist when putting the corset on. Please choose the size based on natural waist measurement. CORSET INSTRUCTION How To Put On Your Corset: 1. At the back of the corset, untie the bow and then fully loosen the laces. It can also help with posture correction if wearing it during work. This will vary between the top and bottom depending on the shape of your body. The corset size selected based on your waist measurements can fit you well as long as your Underbust & Hip/Upper Hip measurements are within the range. Make sure the tape is not loose. All comfort without any annoyance. Choose Corset size based on your waist 11 (28 CM) length for the front (measure from underbust) 12.2 (31 CM) length for the side 13.2 (33.5 CM) length for the back 5 (12.7 CM) length for modesty panel at the back This corset can draw in your waist and flatten your tummy & suitable for Tight-Lacing, Shaping and Waist Training. Note: Corsets require adjustment over a few days. Minimize Your Waist Get 4-5 inches waist reduction after putting Fasten the third hook from the bottom first, then fasten all the remaining hooks at the bottom then all remaining hooks at the top. Removing Your Corset: Untie the bow at the back of your corset strings tugging the laces by pulling it loose from the top all the way down the line. Underbust Measure around the fullest part of the underbust area. The First Time You Wear Your Corset: This corset should feel snug and comfortable. Ties up at the back with Strong Laces/Ribbon at waist level
