Minimize Your Waist Get 4-5 inches waist reduction after putting This corset also provide solid support to your lumbar, middle and lower back. Do not remove the knot at the bottom end of the corset. 2. Detach the front busk fastening and gently loosen the laces at the back. Before adjusting the gap at the back, make sure that the gap would be 34 inches and 12 inches. Total of 26 Steel Bones- 2 Strong Steel Busk Bones (1 inch wide each) at the front, 4 Rigid Steel Plates and 20 Spiral/Flexible Steel Bones around the corset Choose Corset size based on your waist We propose 4-5 inches reduction on your waist when putting the corset on. 20 Spiral/Flexible Steel Bones around the corset Make sure there is 12 inches gap between the two sides of the corset. The centre of the corset should be pulled in the most. It can also help with posture correction if wearing it during work. The size proposed is 4-5 reduction on your waist when wearing the corset. CORSET INSTRUCTION How To Put On Your Corset: 1. At the back of the corset, untie the bow and then fully loosen the laces. Underbust Measure around the fullest part of the underbust area. Refasten those that come undone after fastening the others. 4. Gently pull the long loops of the lace until the corset stays in place without holding it. 5. Starting either from the top or bottom, gently tighten the laces while adjusting the modesty panel in its place and smooth it out. 6. Tie the laces into a bow but do not make a knot. Adjusting Your Corset: You wouldn't wear a brand new pair of shoes out for a long walk, in the same way you don't take your corset out of its package and wear it to it's tightest all day long. 1. Wear the corset so it feels slightly snug, not tight. 2. After 15-30 minutes, pull the lace a bit. 3. Continue to pull the lace a bit every 15-30 minutes, until the corset is fully tightened. This has nothing to do with your bra size. Upper Hip Measure around the top to your hip bone (not the fullest part of your hip). If there is no gap at the back where the lace is, it means the corset is too big for you. 100% Cotton Twill Lining with waist tapeCorset Dimension 12.6 (32 CM) length for the front (measure from centre) 12.2 (31 CM) length for the front (measure from underbust) 11.8 (30 CM) length for the side 12.8 (32.5 CM) length for the back 5” (12.7 CM) length for modesty panel at the back Fasten at the front with Rust Free Eyelets Please choose the size based on natural waist measurement. 2 Strong Steel Busk Bones (1 inch wide each) at the front 4 Rigid Steel Plates Heavy Duty 26 Double Steel Boned Waist Training Satin Underbust Shaper Please choose the corset size based on your waist. Make sure the tape measure is level under your arms and across your back. The corset size selected based on your waist measurements can fit you well as long as your Underbust & Hip/Upper Hip measurements are within the range. Corset FULLY CLOSED Measurements All comfort without any annoyance. This corset can draw in your waist and flatten your tummy & suitable for Tight-Lacing, Shaping and Waist Training. Then remove busk from top down. When newly worn, thegap between panels should be between 34 inches going down to 12 inches over the course of adjustment process. 7. If you want to hide the extra lacing, you can braid it and pass under crossed laces on your corset either from the top or bottom. Measure at this point snug but not too tight. Torso Length Sit straight on a chair, measure from under your bust extending the tape at the top of your thigh.
